Internal Battery Wiring

This eGo-T electronics set is ideal for you to build up your own eGo-T battery mods. It comes with 3.3V regulated output and 5-click protection! It consists of a piece of electronics IC board, a manual button and a plastic holder. It is a perfect match for eGo battery connectors! Please note, the manual button is different from that of the Joye eGo or Joye eGo-T manual battery.

Working Parameters

Static current: <5uA, 2 uA typical

Regulated output voltage: 3.3V-3.4V

Working current: <1.1A (when Heating coil Resistance is 3Ω )

Maximum allowed working current: 2.5A

Battery woltage to trigger charging: <=3.3V

Voltage to stop charging: >=4.2V

Power Saving Model LED flashes for 5 times(250ms on/250ms off), totally 2.5s, then it goes to power-saving mode. Protection Mode When in "on" status, if the button is pressed 5 times in 1.5 seconds, the MOS circuit will be turned off, thus goes into "off" status. When in "off" status, if the button is pressed 5 times in 1.5 seconds, the MOS circuit will be turned on, thus goes into "on" status.